"centrifugal air blower"

HG785 Alloyed Steel Backward Antifraying Boiler Centrifugal Fan Introduction It has the characteristics of not easy dust accumulation and wear resistant, high efficiency and low noise. This series is a range of centrifugal fans with a wide range of performance. It is suitable for discharging gas containing dust, wood chips and finely divided fibers (If it contains hard particles, a dust removal device must be installed in front of the fan.), it can also be used as a general

AC Motor High Temperature Industrial Boiler Primary Air Flue Gas Fan Introduction Of Centrifugal Fan The 9-10 series high pressure fan is generally used for forging furnace and high pressure forced ventilation and widely used for material transportation. It is suitable for conveying air and non-corrosive, unnatural and non-viscous gases. The fan is made of high quality carbon steel, and can also use stainless steel or other metal materials according to customer requirements.

Single Inlet Forward Material Handling Blower Explosionproof Introduction The 9-08 series fan has a large flow rate and moderate pressure. Its suitable for conveying normal temperature or high temperature non-flammable gas (normal air, high temperature gas, corrosive gas, dusty gas), and conveying granule/powder/chip/fiber material. Detail introduction 1. The fan can output very high pressure, suitable for any need to transport high pressure & normal temperature gas

Q345 Single Inlet Steam Boiler Centrifugal Flow Fan Energy Saving Introduction The 4-14 series centrifugal fan is suitable for indoor ventilation in general factories and large buildings. The series of fans can convey corrosive gases containing acid, alkali and chemicalcomponents.Conveying gases are not allowed to contain a sticky, including dust and hard particle acuities were 150 mg/m3, gas temperature of 80 or less and relative humidity of 95% or less, this Kind of fan

HG785 Alloyed Steel High Volume Centrifugal Ventilation Fans Foundry Furnace Introduction Medium requirements for 6-08 series fans: The medium to be transported should be non-corrosive, non-flammable, explosive, and free of viscous substances. The dust and hard particles contained in the medium should be no more than 150mg/m3. Standard centrifugal fans, including single inlet, with a variety of radial bladed, forward curved, backward curved and self-cleaning impellers.

Low-pressure Wear-resistant Centrifugal Fans and Induced Draft Fans for Metallurgical Sintering Processes Product Overview Designed to meet dust emission requirements for electric arc furnace exhaust gas purification equipment, these fans improve workshop environments and ensure dust concentrations comply with industrial enterprise sanitary standards. Suitable for various applications with similar functional requirements. The 5-12 series centrifugal fan is an enhanced version

Stainless Steel V-Belt Driving Forward Coal-Fired Boiler Blower Fan Introduction 1. When the pressure requirement is met, a large gas flow can be output, and the noise is very low. 2. The fan speed can be flexibly set by matching different diameters of belt pulley to make the fan run at the highest efficiency point and reduce energy waste. 3. Motor sliding guides are provided for easy tensioning of the belt to reduce energy loss due to belt slack. 4. When the airflow

Coupling Driving Energy Efficiency Wear Resistant Industrial Centrifugal Fans Introduction The 5-06 series fan can be used in the feeding system of 2-670t/h steam boiler in thermal power plants, it can also meet the requirements of the high-pressure head performance parameters of the fluidized bed furnace. This series of fans can also be used for dust removal, mine ventilation and general ventilation systems. The blower delivers air, and the induced draft fan delivers flue

High Temperature Explosion Protection High Pressure Centrifugal Fan Introduction The 8-17 series high-pressure small-flow fan is designed for applications requiring high pressure. Under the premise of ensuring a certain amount of air, the full pressure can reach the high pressure requirement. It is mainly used for blasting furnace blast and other forced air supply, and can also be used for tunnels to exhaust or supply air through hard pipes. The fans are divided into general