"high temperature fans and blowers"

Single Suction Coupling Driving Forward Biomass Boiler Dust Collector Fan Detail introduction This fan is designed for the purpose of using industrial boiler to work in the high-efficiency area and achieve the energy-saving target. The fan is suitable for equipped with economizer (heater) and smoke and dust removal device. It is a high-efficiency energy-saving product jointly designed by the national fan industry and organized by the national wind power industry and the

High Pressure Centrifugal Ventilation Fans Backward FD Boiler Fan Introduction Of Centrifugal Fan The 9-08 series high pressure fan is generally used for forging furnace and high pressure forced ventilation, and can be widely used to transport materials, transport air and non-corrosive, non-self-igniting, non-viscous substances gas. The fan system running at normal temperature with an impeller diameter of less than 1400 mm does not require additional configuration of bearing

Single Inlet High Volume Explosion Protection Dust Collector Fan Detail introduction Its a high-performance product promoted by the State Economic Commission and the Ministry of Machinery Industry. Fans with an impeller diameter of less than 1400 mm operate at a normal temperature fan system, eliminating the need for additional bearing cooling devices, reducing the amount of user investment and maintenance. When the airflow resistance is increased, the motor load will be

Q345 Coupling Driven Backward Air Supply Explosion Proof Blower Introduction This explosion proof blower fan is designed for the purpose of using industrial boiler to work in the high-efficiency area and achieve the energy-saving target. The motor shaft is elastically connected with the drive shaft. It is not necessary to tighten the belt or replace the belt frequently, and the maintenance workload is small. The fan is made of high quality carbon steel, and can also use

Long Life HG785 Alloyed Steel Materials Drying Centrifugal Flow Fan Introduction The 5-12 series centrifugal fan air flow air flow is an enhanced version of the 5-11 series medium pressure centrifugal fan. The performance of the fan is expressed by parameters such as fan flow, full pressure, spindle speed, shaft power and efficiency. This series of fans can also be used for dust removal, mine ventilation and general ventilation systems. The blower delivers air, and the

HG785 Alloyed Steel Forward Lime Kiln Antifraying Power Plant Fan Introduction Of Centrifugal Fan The 9-10 series high pressure fan is generally used for forging furnace and high pressure forced ventilation and widely used for material transportation. It has the characteristics of high efficiency, low noise, flat performance curve and wide efficient area. Industrial boilers of 5 ~ 35 tons/hour can be used, those with similar intake conditions and suitable performance can be

China AC Motor Long Life Smoke Exhaust High Pressure Centrifugal Fan Introduction Of Centrifugal Fan 9-03 series fan-type iron furnace special high pressure industrial air blower, is suitable for IL/h, 2L/h, 3L/h, 3L/h, 7L/h melting rate of iron furnace blast performance requirements. The bearing box is reserved with the temperature and vibration sensor installation position, which can conveniently install the fan operation monitoring device. Technical data series model

Aluminium Alloyed Industrial Cement Fan Abrasion Resistant Medium Pressure Introduction The 5-12 series centrifugal fan is an enhanced version of the 5-11 series medium pressure centrifugal fan. Such as conveying high temperature/harmful/dangerous gas, hard particles, powder, debris, fiber, forced ventilation, industrial dust collectors, air filtration systems, flue gas desulfurization, flue gas denitration, industrial boiler forced draft and induced draft fan, the material

Alloy Steel Single Inlet Long Lifetime Centrifugal Ventilation Fans Air Supply Introduction The 4-10 series centrifugal Fan can be used for indoor ventilation in general factories and large buildings. No viscous substances are allowed in the gas, and the dust and hard particles contained in the gas are not more than 150 mg/m3. The gas temperature does not exceed 80C, and similar gas properties are also available. Detail introduction Mainly to meet the dust emission